Looking to re-pin the 0.156" pitch harness to your sound board? Here is a list of parts and tools that I recommend.



Sound Boards: (J1) 15-pin, (J2) 2-pin
Sound Board for EBD: (J1) 18-pin, (J2) 2-pin
Sound Board for Centaur: (J1) 15-pin, (J2) 10-pin

2-pin Molex 0.156" Housing: Digikey 0009503021 (pictured is A19970-ND)
10-pin Molex 0.156" Housing: Digikey WM1572-ND
15-pin Molex 0.156" Housing: Digikey WM21149-ND
18-pin Molex 0.156" Housing: Digikey 0009503181-ND
Female Terminal (AWG18-24): Digikey WM2300-ND
Key Molex 0.156:: Digikey WM2404-ND
Crimper AWG26-16 SN-48B (IWISS ICrimp): Amazon I use the smallest die for single wires. The crimping die has two levels. A tighter one for the metal wire. A less tight one for the insulation.

I also have the IWISS SN-01BM for crimping terminals for 0.10" housings. This one accepts AWG-28-20.

You can order other 0.156" Molex housings too. Here is a list of others in your machine.

Solenoid Board: (J5) 15-pin, (J2) 15-pin, (J1) 9-pin
New Aux Lamp AS-2518-52: (J1) 15-pin, (J2) 18-pin, (J3) 20-pin
Old Aux Lamp AS-2518-43: (J1) 15-pin, (J2) 20-pin
Old Power Rec AS-2518-49: (J3) 20-pin, (J2) 10-pin, (J1) 9-pin
Old Power Rec AS-2518-18: (J3) 20-pin, (J2) 10-pin, (J1) 8-pin
Displays 6 and 7 digit: (J1) 20-pin

9-pin Molex 0.156" Housing: Digikey 23-0009503091-ND
10-pin Molex 0.156" Housing: Digikey WM1572-ND
15-pin Molex 0.156" Housing: Digikey WM21149-ND
18-pin Molex 0.156" Housing: Digikey 0009503181-ND
20-pin Molex 0.156" Housing: Digikey WM24381-ND