This is a must-have upgrade for any Bally Mr & Mrs Pacman pinball machine. It is a direct, plug-and-play replacement for the original Pac-Maze PCB (AS-2518-98), also known as the Pac-Lite/Paclite Matrix or Vid-Grid, now redesigned with high-quality red and yellow LEDs. The factory board used 25 yellow and 25 red 7381 incandescent bulbs. My redesigned Pac-Maze board replaces them with 50 yellow and 50 red 5050 package surface-mount LEDs, delivering brighter, more even illumination. The LEDs produce a uniform glow across the insert without exposing the light source - unlike the stock board, where the bulbs are clearly visible. Additional benefits include: up to 20 degF cooler playfield temperatures; brighter, more vibrant colors; and consistent brightness and color across the entire maze. This LED Pac-Maze board is fully compatible with original Bally lamp driver boards, Alltek main driver boards, and Siegecraft LED adapter boards.

Installation:
1) Lift playfield.
2) Remove connectors J1 and J2 on the stock Pacmaze board.
3) Remove 4 lock nuts holding the board & remove the board.
4) Clean the back of the playfield between the holes and use a wet-wipe or Q-tip to clean the underside of the inserts.
5) Mark holes in the back of the playfield for the light divider, drill 1/4" deep holes using a 3/32" drill bit, and mount the light divider.
6) Swap 4 rubber grommets from stock to the new LED Pacmaze board.
7) Install the new LED board with 4 lock nuts.
8) Install J1 and J2 connectors.
9) Lower playfield.

Note: The light divider is mounted to the back of the playfield, not the LED Pac-Maze board. It needs to be on the playfield to block the light from one insert from bleeding into the other. DO NOT mount the light divider to the LED Pac-Maze board. It will not work correctly. DO NOT drill holes in the LED Pac-Maze to mount the light divider. You will break traces.

Here is a shot of how the 3D printed light divider is installed on the underside of the playfield. One of the sides has a notch. Place this notch up so that it clears the bracket in the upper right.


Check out my YouTube video for further information and installation instructions.

Order Details: You will receive version 3 of the board, a light divider to mount to the rear of the playfield, and all the needed hardware (rubber grommets, lock nuts, and screws). Contact me if you have questions about purchase: geeteoh@mchsi.com

Cost is $90 plus $10 shipping to US addresses. The "Buy Now" (Pay-Pal, Debit Card, Credit Card) purchase button below is for US buyers only.

If you are outside the US, do not use the "Buy Now" link. Instead email me at geeteoh@mchsi.com to send an invoice with shipping charges. It is $30 Canada and UK, $40 to Australia, etc. EU countries have long shipping times. I am not shipping into South America. Customs forms are filled out as merchandise and total value of the board(s) shipped. Customs duty/taxes will be collected by your country prior to delivery.

I also make a replacement Squawk and Talk sound board for the Mr Mrs Pac-Man ($240). You can purchase both with the purchase button below.


Note: I have been selling these for over nine years. I have never had one returned because it did not work or the owner did not like it. The price has remained constant from day one. I build these by hand and test every one of them.